FAULTNEST FAULT CODES
Gent Fire & Security Fault Codes
Browse Gent fire & security fault and error codes, meanings, likely causes and diagnostic checks.
AVAILABLE CODES
Choose the fault code
13 published codes currently listed for this manufacturer and category.
Control panel standby battery discharged
The control panel has detected that its standby battery supply is fully discharged.
Control panel battery disconnected
The control panel has detected that the standby battery supply is disconnected.
Battery fault at connected interface, repeat panel or mimic
The connected equipment battery has failed its load test.
Mains supply failure at connected equipment
A monitored interface unit, repeat panel or mimic panel has lost its mains supply.
Fire Alarm Routing Equipment fault
The panel reports a fault associated with the Fire Alarm Routing Equipment connection.
Monitored input open or short circuit
A monitored input line has an open-circuit or short-circuit fault.
Interface input open or short circuit
An input line on an interface device has an open-circuit or short-circuit fault.
Loop device not communicating with the control panel
The panel has lost communication with a device on the detection loop.
Control panel mains supply failure
The fire alarm control panel has detected loss of its mains power supply.
Master alarm wiring open or short circuit
The panel has detected an open-circuit or short-circuit fault on the master alarm wiring.
Integral printer not detected
The control panel is not detecting its integral printer.
Loop wiring short circuit
The panel has detected a short circuit on loop wiring associated with a loop card.
Fire detector or sensor operating outside specification
The panel has identified a sensor or device that is not functioning within its required specification.
CAN'T FIND THE CODE?
Help us add it
Submit a missing Gent code and we will review it before publishing.